Viking RVEWD Installation Instructions - Page 9
Attach the white neutral and black line lead
 |
View all Viking RVEWD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Installation 1 2 2 1 Pull out warming drawer pan until fully extended. Slide finger along right and left side until you reach the black hand latches (located at the front of the rails). Pull up on both the right and left latches and pull out drawer pan support. Electrical opening (from rear) 3 2" 4 (5.1 cm) 2" (5.1 cm) 2 1 1 Feed supply cord up through hole in rear of warming drawer. 5 Remove strain relief bracket and mounting screws on the terminals. 6 1 1 2 2 Attach the white (neutral) and black (line) lead terminals. Attach ground wire to the center terminal. Push supply cord toward terminal block to relieve strain, reattach supply cord strain relief bracket over supply cord. 9
-
1 -
2
-
3
-
4 -
5 -
6 -
7 -
8 -
9 -
10 -
11 -
12
 |
 |
9
Installation
1
2
1
2
Pull out warming drawer
pan until fully extended.
Slide finger along right and left side
until you reach the black hand latches (located at the
front of the rails). Pull up on both the right and left
latches and pull out drawer pan support.
2”
(5.1 cm)
2”
(5.1 cm)
Electrical opening
(from rear)
3
2
1
1
4
Feed supply cord up through
hole in rear of warming drawer.
1
2
5
Remove strain relief bracket and mounting
screws on the terminals.
Attach the white (neutral) and black (line) lead
terminals. Attach ground wire to the
center terminal.
1
2
6
Push supply cord toward terminal
block to relieve strain, reattach supply cord strain
relief bracket over supply cord.