Viking RVGR3302 Use and Care Manual - Page 23

Troubleshooting

Page 23 highlights

Troubleshooting Problem Range will not function. Broil does not work. Possible Cause and/or Remedy Range is not connected to electrical power: Have electrician check power circuit breaker, wiring, and fuses. Temperature control knob is rotated too far past broil position. Oven does not operate in selfclean. Oven is not clean after selfclean cycle. Oven light will not work. Igniters will not work. Igniters sparking but no flame ignition. Igniters sparking continuously after flame ignition. Burner ignites but flame is large, distorted, or yellow. Strong odor and/or smoke is noticed first few times oven is used. Oven indicator light on; oven will not heat Door is not shut tight enough for automatic door latch to lock. Temperature control knob not rotated all the way past clean until it stops. Light bulb is burned out. Range is not connected to power. Circuit is tripped. Fuse is blown. Range is not connected to power. Gas supply valve is in "OFF" position. Gas supply is interrupted. Power supply is not grounded. Power supply polarity is reversed. Igniters are wet or dirty. Burner ports are clogged. Unit is being operated on wrong type of gas. Air shutters not properly adjusted. This is normal burn off of insulation and protective oils in oven. This will go away after using oven a few times. Oven is operating properly. Unit will resume heating function once it has cooled. 23

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28

23
Troubleshooting
Problem
Possible Cause and/or Remedy
Range will not function.
Range is not connected to electrical power:
Have electrician check power circuit breaker,
wiring, and fuses.
Broil does not work.
Temperature control knob is rotated too far past
broil position.
Oven does not operate in self-
clean.
Door is not shut tight enough for automatic door
latch to lock.
Oven is not clean after self-
clean cycle.
Temperature control knob not rotated all the way
past clean until it stops.
Oven light will not work.
Light bulb is burned out.
Range is not connected to power.
Igniters will not work.
Circuit is tripped.
Fuse is blown.
Range is not connected to power.
Igniters sparking but no flame
ignition.
Gas supply valve is in “OFF” position.
Gas supply is interrupted.
Igniters sparking
continuously after flame
ignition.
Power supply is not grounded.
Power supply polarity is reversed.
Igniters are wet or dirty.
Burner ignites but flame is
large, distorted, or yellow.
Burner ports are clogged.
Unit is being operated on wrong type of gas.
Air shutters not properly adjusted.
Strong odor and/or smoke
is noticed first few times
oven is used.
This is normal burn off of insulation and
protective oils in oven. This will go away
after using oven a few times.
Oven indicator light on;
oven will not heat
Oven is operating properly. Unit will resume
heating function once it has cooled.