Viking VDOT Installation Instructions - Page 11

General Information • All openings in the wall behind the appliance or in the floor under the appliance should be sealed. • Keep appliance area clear and free from combustible materials, gasoline and other flammable vapors. • Disconnect the electrical supply prior to servicing. • When removing the appliance for service, disconnect AC power supply and carefully remove the appliance by pulling forward. • CAUTION: The oven is heavy - use care when handling! • Electrical requirements are listed in the product specifications under the electrical requirements section. Recommendations for Unpacking • Products are shipped on pallets with foam footings and corrugated inner-packing Recommendations for Moving • The appliance is heavy - use extreme care when handling! • WARNING: DO NOT use the handle or oven door to lift the oven. Remove lower door before installation to ensure that it is not used to lift the unit. DO NOT remove the upper door. Make sure latches are properly locked before removing door to prevent personal injury to hands and/or fingers. DO NOT lift or carry the door by the handle. • Only proper equipment should be used to move products. • ALWAYS take steps to protect flooring at the installation location when moving products. Exposed floor surfaces should be protected by applying laminate or plywood sheets. Failure to do so may result in scarring and damaging the homeowner's floor • Products are anchored to the pallet using metal straps that are screwed to the bottom of the product and the pallet. • DO NOT remove protective packaging until you are ready to perform the installation. • Remove the corrugated cover by lifting it off the product and remove the innerpacking. • Detach the product from the metal anchor strip by removing the attachment screw. Site Preparation Note: It is recommended that a thorough site inspection be conducted PRIOR to unpacking and moving this appliance. • Confirm available access to adequate power - see electrical requirements. -Double oven units require a 50 amp circuit. • DO NOT remove the protective wrapping from the product control panel until the product is installed. • It is recommended that 3/4" or larger material be utilized to create a support platform for this appliance. CAUTION Avoid any damage to oven vents. The vents need to be unobstructed and open to provide proper airflow for optimal oven performance. •A minimum of 2" (5.1 cm) spacing above and below the oven trim and 2" (5.1 cm) spacing from side trims to any adjacent items or walls is required for ventilation purposes. 11