Viking VDR548 Use and Care Manual - Page 29

Troubleshooting

Page 29 highlights

Troubleshooting Problem Range will not function. Broil does not work. Door will not open. Oven light will not work. Igniters will not work. Igniters sparking but no flame ignition. Igniters sparking continuously after flame ignition. Burner ignites but flame is large, distorted, or yellow. Strong odor and/or smoke is noticed first few times oven is used. Possible Cause and/or Remedy Range is not connected to electrical power: Have electrician check power circuit breaker, wiring, and fuses. Temperature control knob is rotated too far past broil position. Oven is still in self-clean mode. If oven is hot, door latch will release when safe temperature is reached. Light bulb is burned out. Range is not connected to power. Circuit is tripped. Fuse is blown. Range is not connected to power. Gas supply valve is in "OFF" position. Gas supply is interrupted. Power supply is not grounded. Power supply polarity is reversed. Igniters are wet or dirty. Burner ports are clogged. Unit is being operated on wrong type of gas. Air shutters not properly adjusted. This is normal burn off of insulation and protective oils in oven. This will go away after using oven a few times. Oven indicator light on; oven will not heat Oven is operating properly. Unit will resume heating function once it has cooled. 29

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32

29
Problem
Possible Cause and/or Remedy
Range will not function.
Range is not connected to electrical power:
Have electrician check power circuit breaker, wiring, and fuses.
Broil does not work.
Temperature control knob is rotated too far past broil position.
Door will not open.
Oven is still in self-clean mode. If oven is
hot, door latch will release when safe temperature is reached.
Oven light will not work.
Light bulb is burned out.
Range is not connected to power.
Igniters will not work.
Circuit is tripped.
Fuse is blown.
Range is not connected to power.
Igniters sparking but no flame
ignition.
Gas supply valve is in “OFF” position.
Gas supply is interrupted.
Igniters sparking
continuously after flame ignition.
Power supply is not grounded.
Power supply polarity is reversed.
Igniters are wet or dirty.
Burner ignites but flame is large,
distorted, or yellow.
Burner ports are clogged.
Unit is being operated on wrong type of gas.
Air shutters not properly adjusted.
Strong odor and/or smoke is noticed
first few times oven is used.
This is normal burn off of insulation and protective oils in oven. This will go away
after using oven a few times.
Oven indicator light on;
oven will not heat
Oven is operating properly. Unit will resume heating function once it has cooled.
Troubleshooting