Viking VDWU324SS Installation Instructions - Page 12
Notice
View all Viking VDWU324SS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
NOTICE : • Either one of the methods below must be used or the dishwasher will not operate properly. • A hose that attaches to a sink spray can burst if it is installed on the same water line as the dishwasher. If your sink has one, it is recommended that the hose be disconnected and the hole plugged. • The total length of the drain hose is 763/4" (1950mm). If a hose extension is required, a drainage hose of equal quality must be used. • The maximum length must not exceed 157 ½" (4000mm). Otherwise, the cleaning process is negatively influenced. 6.6.1 UNDER THE SINK DRAIN Install a Y-branch tail pipe. (Figure A) NOTICE : You must add a loop at least 28" (710mm) above the floor of the cabinet and above the drain connection in the drain hose to prevent waste water from not draining properly, and causing either poor washing results or a bad odor. 6.6.2 INSTALLING AN AIR GAP If the local ordinance requires an air gap (Figure B). NOTICE : Check with local ordinance for type of air gap required. 6.6.3 DISPOSAL Remove the drain connection plug before attaching the drain hose from the dishwasher. Every disposal has a hook up for a dishwasher; consult your disposer manual for correct connection. (Figure C) 10 USA