Viking VGCC536 Installation Instructions - Page 12
Service & Registration, Performance Checklist, Final Preparation
View all Viking VGCC536 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Final Preparation • All stainless steel body parts should be wiped with hot, soapy water and with a liquid cleaner designed for this material. If buildup occurs, DO NOT use steel wool, abrasive cloths, cleansers, or powders! If it is necessary to scrape stainless steel to remove encrusted materials, soak with hot, wet cloths to loosen the material, then use a wool or nylon scraper. DO NOT use a metal knife, spatula, or any other material tool to scrape stainless steel! Scratches are almost impossible to remove. Performance Checklist A qualified installer should carry out the following checks: h Check top burner ignition. See 1-1/2" (3.8 cm) drawing for proper flame height on HI. The low flame should light at every port. 3/8" (0.95 cm) h Check oven bake function-bake burner on full power. h Check Convection bake function-bake and broil burners the same with the convection fan on (VGSC self-clean models). h Check convection broil function-broil burner at full power with convection fan on (VGSC self-clean models). h Check convection fan function-convection fan comes on when switch is turned on (VGCC models). h For self-cleaning models check self-clean function-door will lock in approximately 30 seconds, the center and outside broil elements will turn on and the bake element will turn on at partial power. Check broil elements through window to make sure they are on, then abort self-clean cycle to unlock door. NOTICE When conducting performance test, DO NOT run self-clean cycle for more than 10 minutes with oven racks inside oven. This could cause them to discolor due to the high temperature required for self-cleaning. 22 Service & Registration Only authorized replacement parts may be used in performing service on the appliance. All servicing should be referred to a qualified technician. Contact Viking Range Corporation, 1-888-VIKING1 (845-4641), for the nearest service parts distributor in your area or write to: VIKING RANGE CORPORATION PREFERRED SERVICE 1803 Hwy 82W Greenwood, Mississippi 38930 USA Record the following information indicated below. You will need it if service is ever required. The serial number and model number for your appliance can be found by opening the door and looking under the control panel. A duplicate label is located on the back side of the range. Model number Serial number Date of purchase Date installed Dealer's name Address These installation instructions should remain with the unit for future reference. 23