Viking VMOD Installation Instructions - Page 4

DrawerMicro Oven Measurements 1 L B D F G I J I A C E K Q M H N O P A. 6" (152.40 mm) B. Suggested electrical outlet location* C. Anti-Tip block D. 5" (127 mm) E. 3-1/2" (88.90 mm) F. 4" (101.60 mm) G. 22-1/8" (561.98 mm) opening H. 14-13/16" (376.24 mm) to bottom of Anti-Tip block I. Allow 7/8" (22.23 mm) overlap J. 23-1/2" (596.90 mm) minimum depth K. Allow 3/16" (4.76 mm) overlap L. 36" (914.4 mm) countertop height M. Allow 1/8" (3.17 mm) overlap N. Floor must support 100 lb (45.4 kg) O. 19" (482.60 mm) to top of floor P. 24" (609.6 mm) cabinet minimum Q. 15-9/16" (395.27 mm) opening 2 B C J F E A G I D H A. 21-5/8" (549.28 mm) B. 4-11/16" (119.06 mm) C. 1-3/4" (44.45 mm) D. 21-7/8" (555.60 mm) E. 23-7/8" (606.43 mm) F. 15-7/8" (403.22 mm) G. 14-19/32" (370.69 mm) H. 1-9/64" (29 mm) door thickness I. 15" (381 mm) auto drawer opening J. 4" (101.6 mm) Figures 1 and 2 contain many DrawerMicro measurements for reference when planning the drawer's location. This DrawerMicro can be installed below any electric or gas wall oven. * Can also be installed using an electrical outlet in an adjacent cabinet within the area where the provided electrical cord can reach. Power cord access hole in cabinet should be a minimum 1-1/2" diameter hole and deburred of all sharp edges. IMPORTANT - Always allow sufficient power cord length to the electrical outlet to prevent tension. Always check electrical codes for requirements. E4