Viking VMOS201SS Installation Instructions - Page 1

Viking Installation Guide IMPORTANT-Please Read and Follow! • Before beginning, please read these instructions completely and carefully. • Be sure to DISCONNECT THE PLUG of the microwave oven from the electrical outlet before installing the built-in trim kit. Remove the turntable from the oven cavity. • Because the kit includes metal parts, caution should be used in handling and installation to avoid the possibility of injury. • Do not remove permanently affixed labels, warnings, or plates from the product. This may void the warranty. • Please observe all local and national codes and ordinances. • The installer should leave these instructions with the consumer who should retain for local inspector's use and for future reference. • This built-in trim kit is designed for use only with Viking convection and Conventional microwave ovens specifying built-in trim kit VMTK272, VMTK302, VMTK362, VMTK277, VMTK307 or VMTK367 on the rating label on the bottom face plate of the oven cavity. • Your oven can be built into a cabinet or wall by itself or above any electric wall oven or warming drawer. Parts Included in VMTK kits Front Frame Assembly QTY 1 Back Frame QTY 1 Front Frame QTY 1 Bottom Duct Assembly QTY 1 27" & 30"Surface Mount Template 2-sided or 36"Surface Mount Template single-sided QTY 1 Maximum Cutout Opening Width 24-11/16" (627.06 mm) Minimum Cutout Opening Width 24-3/8" (619.13 mm) BUILT-IN TRIM KIT TEMPLATE FOR CUSTOM SERIES MICROWAVE OVEN Center Line USE THIS SIDE OF TEMPLATE FOR MODELS VMTK272 and VMTK302 ONLY. 1. Align the mounting template center line with the center of the cutout and the floor line with the floor of the cutout. Tape it into place. 2. For VMTK272, predrill 4 holes marked A with a 1/16" drill bit. For VMTK302, predrill 4 holes marked B with a 1/16" drill bit. 3. Remove template from the cabinet. Distance between holes A 25-9/16" (649.3 mm) Distance between centerline to holes 12-13/16" (324.65 mm) Distance between holes B 28-9/16" (725.5 mm) Distance between centerline to holes 14-5/16" (362.75 mm) Floor Line of Cutout Opening 1-5/32" (29.6 mm) TINSKB133MRR0 * 15-13/32" (391.45 mm) Maximum Height distance between holes 14-1/4" (361.825 mm) Minimum Cutout Opening Height 16-3/4" (425.5 mm) Maximum Cutout Opening Height 17" (431.8 mm) Duct (A)-1 QTY 1 * Duct (A)-3 QTY 1 * Duct (A)-2 QTY 1 * Screw A (1/2" length) QTY 10 * Duct (B) QTY 1 * Screw B (1-3/4" length) QTY 4 Cushion QTY 3 Duct (C) QTY 1 * Screw C (3/4" length) QTY 2 *VMTK277, VMTK307 and VMTK367 ONLY. Custom Series Convection / Conventional Microwave Built-In Trim Kit 111 Front Street Greenwood, Mississippi 38930 USA