Viking VSOT Installation Instructions - Page 16

HPeerafodrlminaence Checklist - Lower Oven Loading the Software This first time you turn on the oven after installation, the oven will load the software. This process should take no longer than 10 minutes. DO NOT attempt to operate the oven while the software is loading. Note: If necessary to relaunch the software, hold down the left (upper) power off button for 5 seconds. Note: To fully relaunch software and the memory and program code (the "firmware"), the oven must be powered off at the circuit breaker. Control Panel LED Light Ring Power Off Speedcook Oven Digital Display Power Off Lower Oven USB Port (Top of Control Panel) Speedcook Oven Favorites Food item Cook mode Cookbooks Search 02:55 Lower Oven ® Speedcook Oven Light Speedcook Oven Lock Clock Control Panel Lower Oven Lock Lower Oven Light A qualified installer should carry out the following checks: 1. Check oven bake function-bake element on full power, center and outside broil elements at partial power. Convection bake function- bake and broil elements the same with the convection fan on. 2. Check high broil function-both broil elements at full power. Convection broil function is the same with convection fan on. 3. Check low broil function-inner broil element only. 4. Check self-clean function-Door will lock in approximately 30 seconds, the center and outside broil elements will turn on and the bake element will turn on at partial power. Check broil elements through window to make sure they are on, then abort self-clean cycle to unlock door. CAUTION: Do not run self-clean cycle check for more than 10 minutes with the oven racks and rack supports inside oven to avoid discoloration due to the high temperature. Any adjustments necessary that are a result of the installer not following instructions will be the responsibility of the installer, dealer or the end user of the product. 16