Viking VWH4878TSS Use and Care Manual - Page 8

Product Care Cleaning and Maintenance Cleaning Brass Parts All brass body parts should be wiped regularly with hot soapy water. When hot soapy water will not do the job, use every day household cleaners that are not abrasive. Cleaning Ductless Venting Chamber (Professional Hoods Only) 1. Remove the middle vent by gently raising up and pulling out. 2. Use the same cleaning directions as in "Cleaning the Hood Canopy" section. 3. After cleaning, replace the middle vent. Replacing the Light Bulbs When removing bulbs use an oven mitt to protect your hand in case the bulb breaks. Halogen Lights 1. Unscrew halogen bulb. 2. Replace the bulb with a 120 volt, 50-watt halogen bulb. Infrared Heat Lamp 1. Unscrew infrared bulb from heat lamp socket. 2. Replace the bulb with an R40, 120 volt, 250-watt infrared bulb. 1 1 2 2 1 1 2 14 Service Information If service is required, call your dealer or authorized service agency. The name of the authorized service agency can be obtained from the dealer or distributor in your area. Have the following information readily available. • Model number • Serial number • Date purchased • Name of dealer from whom purchased Clearly describe the problem that you are having. If you are unable to obtain the name of an authorized service agency, or if you continue to have service problems, contact Viking Range Corporation at 1-888-VIKING1 (845-4641), or write to: VIKING RANGE CORPORATION PREFERRED SERVICE 1803 Hwy 82W Greenwood, Mississippi 38930 USA Record the information indicated below. You will need it if service is ever required. The model and serial number for your hood is located behind the baffle filter on the left side panel in the lower right corner. Model no Serial no Date of purchase Date installed Dealer's name Address If service requires installation of parts, use only authorized parts to ensure protection under the warranty. THIS MANUAL SHOULD REMAIN WITH THE HOOD FOR FUTURE REFERENCE. 15 Product Care