Viper 160XVL Owner Manual - Page 18
To perform Valet Take-Over
View all Viper 160XVL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
To turn the rear defogger output ON: 1. Simultaneously press & release the + + buttons on the remote control. 2. The lights will flash 3 times. 3. The rear defogger output will once again activate when the vehicle is remote started. NOTE: If the remote start is on the lights will turn off then flash 3-times before returning to their normal output and the defogger output will activate as programmed. Valet Take-Over The Valet Take-Over feature allows the vehicle to remain running after the key has been removed from the ignition. This feature is useful for occasions when you wish to exit and lock the vehicle for short periods of time, but would like to leave the motor running and the climate controls on. To perform Valet Take-Over: 1. Before turning off the engine, press and release on the transmitter twice in 3 seconds (or press and release the optional momentary switch). 2. Turn the ignition key to the OFF position. (The engine will stay running.) 3. Once the vehicle has started, it will run for the pre-programmed period of time (12, 24, or 60 minutes) or until a shutdown input is triggered. © 2005 Directed Electronics-all rights reserved 15