Viper 3102V Quick Reference - Page 10

ign­ i­tion key and know where the Valet button is located. Be sure to check with the installer for the location and the number of presses of the Valet button required to disarm the system. To disarm the security system: 1. Turn the ignition to the ON position. 2. Press and release the Valet button the preset number of times (one, the factory setting, to five times) within 15 seconds. After five seconds the syst­em disarms. If the system does not disarm, you may have waited too long. Turn the ignition off and on and try again. Location of Valet Button Number of Pulses The unit may respond to one to five pulses of the Valet button, when disarming. Check with your installer to discuss how you want the system configured. Note: as a precaution, if programmed for passive arming the system should be placed into Valet Mode until a remote is available. Silent mode To temporarily turn off the arm or disarm chirps, use Silent Mode™. Press AUX for less than one second before arming or disarming, and the confirmation chirp(s) will be eliminated for that one op­era­ ­tion only. If you want the arm/disarm chirps turned off permanently, your dealer can do this for you. The Warn Away response to lighter impacts is bypassed if the system 8 © 2013 Directed. All rights reserved.