Viper 3203 Owner Manual - Page 18

Remote Control Configuration - responder

Get Viper 3203 PDF manuals and user guides View all Viper 3203 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 18 highlights

Remote Control Configuration Remote Programming The Responder LE and 1-way companion remote controls have operations that can be configured to a user's personal preferences. The following instruction will direct you through the available programming options for both remote controls. To enter programming, press and hold the button for 8 seconds, the remote emits one long beep and the transmit LED turns on to indicate the main menu is accessed. To exit programming or go back to a previous menu, press and release the button. 1 short and 1 long beep is emitted for each step back and when programming is exited the transmit LED turns off. Note: The 1-way remote does not emit any confirmation beeps. Pairing a 1-way or 2-way remote control Note: The remote control may or may not emit sounds during this operation. Prepare the vehicle 1. Open a door. 2. Turn the ignition On. 3. Press and release then press and hold the control center button. The control center LED flashes and siren chirps one time to confirm the system is prepared. 4. Release the button and proceed below. Note: Begin pairing within 60 seconds or the system will exit (indicated by a long siren chirp) and need to be prepared again. © 2009 Directed Electronics. All rights reserved. 15

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
15
© 2009 Directed Electronics. All rights reserved.
Remote Control Configuration
Remote Programming
The Responder LE and 1-way companion remote controls have opera-
tions that can be configured to a user’s personal preferences. The fol-
lowing instruction will direct you through the available programming
options for both remote controls.
To enter programming,
press
and
hold
the
button for 8 seconds,
the remote emits one long beep and the transmit LED turns on to indi-
cate the main menu is accessed.
To exit programming or go back to a previous menu,
press
and re-
lease the
button. 1 short and 1 long beep is emitted for each step
back and when programming is exited the transmit LED turns off.
Note:
The 1-way remote does not emit any confirmation beeps.
Pairing a 1-way or 2-way remote control
Note:
The remote control may or may not emit sounds during this
operation.
Prepare the vehicle
Open
1.
a door.
Turn
2.
the ignition On.
Press
3.
and
release
then
press
and
hold
the control center button.
The control center LED flashes and siren chirps one time to con-
firm the system is prepared.
Release
4.
the button and proceed below.
Note:
Begin pairing within 60 seconds or the system will exit (indi-
cated by a long siren chirp) and need to be prepared again.