Viper 3203 Owner Manual - Page 29
Out of Range, No Remote Output, Car Select - 2 way responder le
View all Viper 3203 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Out of Range Each time a command is performed the Responder LE will expect a command confirmation from the system. If a command confirmation is not received the and transmit LED's flash and a long fault tone plays as an alert. No Remote Output Occasionally when a command is performed the remote may not generate a command confirmation output or out of range output. This indicates that the system received the command but it was an incomplete command (e.g. aux button pressed too short to activate the trunk release) or it was an illegal message (e.g. the command was corrupted due to local RF interference). These are temporary normal functions of the system and remote, perform the command again within 10 seconds to return to normal operation. Car Select Car 2 must first be turned on (See Remote Control Configuration section to turn on). 1. Press and hold the button for 3 seconds. The remote flashes the transmit LED and beeps once or twice to indicate the selected car is 1 or 2. 2. Release the button, then press and release while the transmit LED and beeps continue to perform car select. Once the car is selected a command can be performed by pressing one of the command buttons. Note: The 1-way remote does not emit any indication beeps. The transmit LED flashes once or twice to indicate car one or car two. 26 © 2009 Directed Electronics. All rights reserved.