Viper 5101 Owner Manual - Page 40

The LED on the Control Center comes - quick reference

Page 40 highlights

✂ Cut along the dotted line and fold to keep in purse or wallet for a quick and easy reference. • Remote Start Press . The AUX parking lights turns on (if connected). The vehicle starts and runs for the programmed duration. • Rear Defogger* Press four-times, and then press (oAUnX ly after remote start is On.) The parking lights flash 4 times confirming activation of the defogger output. • To disable the remote start system 1Move the shutdown toggle switch to the Off position. 2 Location of Shutdown Toggle Switch • Valet Mode Press two-times and then 3 . The LED on the Control Center comes 4 on solid to indicate the system is in valet. The same sequence on the remote can be used to exit valet made. The LED turns off when Valet mode is exited. A U X 5 • Pit Stop mode 6 1. Before turning Off the engine, press and release the bAuUXtton. Then wait a few seconds. 2. Turn the ignition key to the Off position. 3. Exit the vehicle and lock the doors with the remote. The engine will remain running until the programmed time elapses or a shut-down input is received. *Additional parts and labor may apply. ✂ 32 © 2009 Directed Electronics. All rights reserved.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44

32
© 2009 Directed Electronics. All rights reserved.
Remote Start
Press
. The parking lights turns on (if connected). The vehicle starts
and runs for the programmed duration.
Rear Defogger*
Press
four-times, and then press
(only after remote start is On.)
The parking lights flash 4 times confirming activation of the defogger
output.
To disable the remote start system
Move the shutdown toggle switch to the Off position.
Location of Shutdown Toggle Switch___________________
Valet Mode
Press
two-times and then
. The LED on the Control Center comes
on solid to indicate the system is in valet. The same sequence on the
remote can be used to exit valet made. The LED
turns off when Valet
mode is exited.
Pit Stop mode
Before turning Off the engine, press and release the
1.
button.
Then wait a few seconds.
Turn the ignition key to the Off position.
2.
Exit the vehicle and lock the doors with the remote.
3.
The engine will remain running until the programmed time elapses
or a shut-down input is received.
*Additional parts and labor may apply.
Cut along the dotted line and fold to keep in purse or wallet for a quick and easy reference.