Viper 5501 Owner Manual - Page 34

Temperature Reporting During Remote start the vehicle interior is checked regularly for temperature changes. If a change in temperature is detected this report will be sent to the remote for display. Each time the remote receives this report it will beep, update, and display the newest temperature information using the Temperature Gauge icon. Note Temperature report must be turned on by an authorized Directed dealer. Remote Start Time-out Alert During remote start a message is sent three minutes before and again at one minute before the engine turns off. The RUNTIME LOW text plays with tones as an alert to reset the runtime if desired. Manual Transmission Start (MTS mode) When installed into a manual transmission vehicle, the system requires that the MTS mode is properly set when parking. If MTS mode is not properly set or is defeated after being properly set the system will not start the engine and the remote start error text and tones play as an alert. 1. With the engine running, set the parking brake and leave the engine running. For Pit Stop or Turbo Timer mode (to leave the engine running after Locking) open the driver door. 2. Release the foot brake (if pressed during Step 1), or press and release the foot brake anytime. As long as the engine is running there is no time limit to perform this step. 3. Within 20 seconds of foot brake release, press any command button on the remote, after 20 seconds return to Step 2 (For Turbo 32 © 2009 Directed Electronics. All rights reserved.