Viper 5701 Owner Manual - Page 34

Note Temperature report must be turned on by an authorized Directed dealer. Remote Start Time-out Alert During remote start a message is sent three minutes before and again at one minute before the engine turns off. The LED, Remote Start LED flash and several tones play as an alert to reset the runtime if desired. Manual Transmission Start (MTS mode) When installed into a manual transmission vehicle, the system requires that the MTS mode is properly set when parking. If MTS mode is not properly set or is defeated after being properly set the system will not start the engine. 1. With the engine running, set the parking brake and leave the engine running. For Pit Stop or Turbo Timer mode (to leave the engine running after arming), open the driver door. 2. Release the foot brake (if pressed during Step 1), or press and release the foot brake anytime. As long as the engine is running there is no time limit to perform this step. 3. Within 20 seconds of foot brake release, press any command button on the remote, after 20 seconds return to Step 2 (For Turbo Timer Mode, press the optional dash mounted activation button or send the Timer Mode command. 4. The parking lights flash 5 times to confirm MTS mode enable and the remote start activates the ignition outputs. The Remote Start LED and On tones play to confirm. 5. Turn Off and remove the key from the ignition switch, the engine remains running. 6. Exit the vehicle, close all the doors and arm the system. © 2011 Directed Electronics. All rights reserved. 31