Viper 5701 Owner Manual - Page 39
Out of Range, No Remote Output, Feature not Available
View all Viper 5701 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Out of Range Each time a command is performed the Responder LE will expect a command confirmation from the system. If a command confirmation is not received the and transmit LED's flash and a long fault tone plays as an alert. No Remote Output Occasionally when a command is performed the remote may not generate a command confirmation output or Out of Range output. This indicates that the system received the command but it was an incomplete command (e.g. Aux button pressed too short to activate the trunk release) or it was an illegal message (e.g. the command was corrupted due to local RF interference). These are temporary normal functions of the system and remote, perform the command again within 10 seconds to return to normal operation. Feature not Available The Feature Not Available output ( LED on and long fault tone) is a generic one which varies in cause and solution depending upon the command used: Command Cause Runtime Reset Remote Start is Off Sensor Bypass System is not armed Defroster Remote Start is Off. Not configured for this. Reason/Solution Only available when Remote Start is On Only available when system is armed Only available when Remote Start is On. Only available when configured for Defroster control. 36 © 2011 Directed Electronics. All rights reserved.