Vizio S3820w-C0 Quickstart Guide - Page 11

LED INDICATORS LED Indicators are located here: The LED Indicators will behave differently with each button on the remote control. Function LED Behavior Analog Audio In - AUX (1) Description Press the INPUT button on the remote to cycle through the available inputs: Input Analog Audio In - AUX (2) Coaxial In - Digital (3) Digital Optical Audio In Optical (4) Bluetooth • Analog Audio In - AUX Stereo RCA (1) • Analog Audio In - AUX Stereo 3.5mm (2) • Coaxial In- Digital (3) • Digital Optical Audio In - Optical (4) • Bluetooth Bluetooth Pairing DTS TruVolume On/Off (When searching for device) Flash from Left to Right and back continuously. Press and hold the button on the remote. The Sound Bar will be discoverable for 15 minutes. You can now search for the Sound Bar (VIZIO S3820w) using your Bluetooth Device. The sound bar will power down if no device is found. Note: Set your Bluetooth device into pairing mode prior to the Sound Bar. TruVolume On: TruVolume Off: Press the TVOL button to enable/disable TruVolume. When enabled (On), TruVolume provides a consistent and comfortable volume level for a more enjoyable listening experience. DTS TruSurround On/Off Treble Levels Bass Levels Dolby Digital TruSurround On: TruSurround Off: Press the TSHD button to enable/disable DTS TruSurround. When enabled (On), all inputs will produce virtual surround sound. When disabled (Off), all sources will playback in stereo. Two center LEDs indicate Treble level 0. Press the TREBLE button then press the Next/Previous button to increase/decrease the treble level. The LED indicators will move to the right with increasing levels and to the left with decreasing levels. Two center LEDs indicate Bass level 0. Press the BASS button then press the Next/Previous button to increase/decrease the bass level. The LED indicators will move to the right with increasing levels and to the left with decreasing levels. Dolby Digital Logo. Dolby Digital is only available on either the Coaxial In or Digital Optical Audio In inputs. When a Dolby Digital signal is detected, the Dolby Digital logo will light up for 5 seconds before fading away.