Vtech KidiGo NexTag User Manual - Page 5

Getting Started

Get Vtech KidiGo NexTag PDF manuals and user guides View all Vtech KidiGo NexTag manuals
Add to My Manuals
Save this manual to your list of manuals

Page 5 highlights

6. Finally, pull the end of the Arm Band through the other slot of the buckle and under the tab. 7. Now, you're ready to go! GETTING STARTED Battery Removal and Installation 1. Make sure the unit is turned Off. 2. Locate the battery cover on the back of each unit, use a screwdriver to loosen the screw and open the battery cover. 3. Remove old batteries by pulling up on one end of each battery. 4. Install 2 new AA (AM-3/LR6) batteries into each unit following the diagram inside the battery box. (For best performance, alkaline batteries or fully charged Ni-MH rechargeable batteries are recommended.) 5. Replace the battery cover and tighten the screw to secure. 555

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
5
5
5
6.
Finally, pull the end of the
Arm Band
through
the other slot of the buckle and under the tab.
7.
Now, you’re ready to go!
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned
Off
.
2. Locate the battery cover on the back of
each unit, use a screwdriver to loosen
the screw and open the battery cover.
3. Remove old batteries by pulling up on
one end of each battery.
4. Install 2 new AA (AM-3/LR6) batteries
into each unit following the diagram
inside the battery box. (For best
performance, alkaline batteries or fully
charged Ni-MH rechargeable batteries
are recommended.)
5. Replace the battery cover and tighten the screw to secure.