Vtech KidiZoom Camera Pix Plus - Pink User Manual - Page 10

CONNECTING TO A COMPUTER You can connect KidiZoom® Camera PixTM Plus to a PC or Mac computer by using a micro USB cable (not included). Once connected, you can transfer files between the camera and computer following these steps: • Turn the camera Off before connecting to a computer. • Pull up the rubber cover of the USB port at the bottom of your camera. • Insert the small end of the USB cable (not included) into the USB port on the camera. • Insert the larger end of the USB cable (not included) into a USB port on your computer. A USB port is usually marked with this symbol . • Two removable drives called VTech 5489 and VT SYSTEM will appear. VTech 5489 is for storage of your data, VT SYSTEM is for storage of system data and cannot be accessed. Note: If there is a memory card in the camera, the removable drive will show the contents of the memory card only. To avoid any potential damage to your KidiZoom® Camera PixTM Plus: • When the USB cable (not included) is not connected to the camera, ensure the USB rubber cover is fully covering the USB port of the camera. • Please ensure the microSD card slot rubber cover of the camera is fitted in place. Note: Once the camera is connected to your computer, do not insert or remove the memory card and do not disconnect the camera while files are transferring. After you finish, remove the camera by taking the appropriate steps for your system to safely remove hardware from your computer. You can then physically unplug the camera from the computer. 10