Vtech LS6425-3 User Manual (LS6425-3 User Manual) - Page 60

Appendix No battery No line No battery is installed. Follow the directions for battery installation on page 3 to install the battery before charging. There is no telephone line connected. No signal, call ended Communication between the handset and telephone base is lost during a call. Not available at this time One handset is already viewing the caller ID log or directory, and another handset attempts to review it. You attempt to place a PTT call to another handset which is on an outside call or intercom call, or accessing the answering system. Number already saved The telephone number entered is already stored in the directory. Out of range OR No pwr at base The handset cannot communicate with the telephone base. Check the telephone base power connection or move closer. ** Paging ** The system handset is being paged. Phone The handset is on a call. Place in charger The battery is very low. Place the handset in the telephone base or charger for recharging. Rec mem full The answering system memory is full Rec mem low Ringer muted Ringer off The answering system has less than three minutes of recording time left. The ringer is muted temporarily during an incoming or intercom call. The ringer is turned off. Saved Your selection has been saved. Speaker Unable to call. Line in use Unable to call. Try again Unable to save XX Missed calls XX New messages The handset speakerphone is in use. You are attempting to predial a number while the telephone line is in use. You try to join a call when there are already four handsets on that call, or to make an outside call when another handset is transferring a call with the intercom feature. You are attempting to save a caller ID entry without a name and number into the directory. There are XX calls that have not been reviewed in your caller ID log. There are XX new messages in the answering system. 56