Vtech TL7600 User Manual - Page 11
To register a headset to the DECT headset base, ON/OFF
View all Vtech TL7600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Getting started Registering the headset To register a headset to the DECT headset base: 1. Make sure the battery is properly installed in the headset (see page 3). The ON/OFF light flashes twice every five seconds to indicate the headset is not registered. 2. Place the headset in the headset charger and allow it to charge for at least five minutes before beginning registration. Remove the headset from the charger and replace the headset back into the charger. 3. On the headset base, press and hold the PAIR button until the MUTE light on the headset base turns on (about four seconds) and release the button. Registration may take about 30 seconds to complete. The MUTE light on the headset base turns off. The headset ON/OFF light turns blue on the first headset registered. The headset ON/OFF light turns orange on the second headset registered. To verify registration was successful, press the headset ON/OFF button and check for a dial tone. If the registration is not successful, the ON/OFF light on the headset flashes twice every five seconds. To reset the headset, remove the headset from the headset charger and try the registration process again.