Vtech Three Handset Cordless Phone System with Digital Answering Device and Call - Page 64
ANS ON/OFF, Make sure the answering system is on.
View all Vtech Three Handset Cordless Phone System with Digital Answering Device and Caller ID manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
Troubleshooting Problem Suggestion The answering system does not answer after the number of rings to which I programmed it. • Make sure the answering system is on. When the answering system is on, the red light on the ANS ON/OFF key should be lit. • If toll saver is activated, the number of rings changes to two when there are new messages recorded (page 37). • If the memory is full or if the answering system is off, the system will answer after ten rings. • In some cases, the answering system will be affected by the ringing system used by the local telephone company. The outgoing announcement is not clear. • When recording the announcement, make sure you speak in a normal tone of voice about nine inches from the telephone base. • Make sure there is no background noise (television, music, traffic, etc.) when recording. The messages on the • Press VOL system are very difficult to hear. on the telephone base to increase the speaker volume. The answering system • Make sure the answering system is on. does not record • If the answering machine memory is full, it will not record new messages until some old messages. messages are deleted. The messages on the answering system are incomplete. • If a caller leaves a very long message, part of it may be lost when the system disconnects the call after four minutes. • If the memory on the system becomes full during a message, the system stops recording and disconnects the call. • If the caller's voice is very soft, the system may stop recording and disconnect the call. 60 www.vtechphones.com