Vtech Three Handset Cordless Phone System with Digital Answering Device and Call - Page 65
If the telephone is not responding normally, try putting the cordless handset in the telephone
View all Vtech Three Handset Cordless Phone System with Digital Answering Device and Caller ID manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
Troubleshooting Problem Suggestion The answering system does not respond to remote commands. • Make sure your remote access code is correct (page 39). • Make sure you are calling from a touch-tone telephone. When dialing a number, there should be tones. If there are clicks, then it is not a touch-tone telephone and cannot activate the answering system. • The answering system may not detect the remote access code when your announcement is playing. Wait until the announcement is over before entering the code. • There may be interference on the telephone line you are using. Press the dial pad keys firmly when dialing. Common cure for electronic equipment. • If the telephone is not responding normally, try putting the cordless handset in the telephone base or the charger. If it does not respond, try the following (in the order listed): • Disconnect the power to the telephone base. • Disconnect the battery on the cordless handset. • Wait a few minutes before connecting power to the telephone base. • Re-install the battery and place the cordless handset in the telephone base or charger. • Wait for the cordless handset to synchronize its connection with the telephone base. Allow up to one minute for this to take place. Appendix www.vtechphones.com 61