Waring CB15P Instruction Manual - Page 8

Cleaning & Sanitizing Instructions for All Waring

Get Waring CB15P PDF manuals and user guides View all Waring CB15P manuals
Add to My Manuals
Save this manual to your list of manuals

Page 8 highlights

4. Press the green STANDBY button to turn on the blender. Green LED will illuminate and remain steady. Select the desired speed with the variable speed control knob. Press the red START/STOP button to begin blending. You may change the speed with the variable speed control knob anytime during blending. When finished blending, press START/STOP button. For momentary operation, press the gray PULSE button; motor will run on HIGH speed until the button is released. The green LED will blink during operation. 5. Always hold container with one hand when starting and while blending. Never operate without container lid properly clamped in place. 6.  Allow motor to come to a complete stop before removing container. Never place the container on the motor base or remove it from the motor base while the motor is running. 7. Press the STANDBY button again to turn off the blender. 8. Remove the container from the motor base and empty the contents. 9.  Wash and dry container after each use. See separate Cleaning & Sanitizing Instructions for All Waring Blenders. 10. Not for water-jet cleaning. 11.  The use of ear protection is recommended during extended operating periods. TO REALIZE MAXIMUM SERVICE LIFE, OBSERVE THE FOLLOWING PRECAUTIONS: 1. Do not lubricate container bearing, drive shaft, or shaft seals. These parts are lubricated and sealed at the factory and do not require any further lubrication. 8

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
8
4.
Press the green STANDBY
button to turn on the
blender.
Green LED will illuminate and remain steady.
Select the desired speed with the variable speed
control knob. Press the red START/STOP
button to
begin blending. You may change the speed with the
variable speed control knob anytime during blending.
When finished blending, press START/STOP
button.
For momentary operation, press the gray PULSE
button; motor will run on HIGH speed until the button
is released. The green LED will blink during operation.
5.
Always hold container with one hand when starting
and while blending. Never operate without container
lid properly clamped in place.
6.
Allow motor to come to a complete stop before
removing container. Never place the container on the
motor base or remove it from the motor base while
the motor is running.
7.
Press the STANDBY
button again to turn off the
blender.
8.
Remove the container from the motor base and
empty the contents.
9.
Wash and dry container after each use. See separate
Cleaning & Sanitizing Instructions for All Waring
Blenders.
10.
Not for water-jet cleaning.
11.
The use of ear protection is recommended during
extended operating periods.
TO REALIZE MAXIMUM SERVICE LIFE, OBSERVE THE
FOLLOWING PRECAUTIONS:
1.
Do not lubricate container bearing, drive shaft,
or shaft seals. These parts are lubricated and
sealed at the factory and do not require any further
lubrication.