Waring WFP11SW Instruction Manual - Page 8
Cleaning And Maintenance
View all Waring WFP11SW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
CLEANING and Maintenance Clean the food processor and accessories prior to initial use and after each use. Do not use harsh abrasive-type cleaners on any part of the food processor. Wash the motor shaft with a small brush. Wash, rinse, sanitize and dry the bowl, covers and S-blade prior to initial use, and after use, unless they will be used again immediately. These items are all dishwasher safe, and may be cleaned and rinsed in the dishwasher instead of manually in the sink. The bowl cover has a black seal around its outer rim that is easily removable for cleaning and should be cleaned periodically. There are three small holes on the outer lip of the top of the cover for pushing the seal out. Use a small, dull object like a toothpick or paper clip, to push the seal downward and out of the groove. DO NOT USE ANYTHING SHARP THAT CAN CUT THE SEAL. Hand wash with warm soapy water, rinse, and dry. To reassemble, insert the clean and dry seal back into the groove with your fingers, with the round edge at the top and the slotted edge at the bottom, facing in. Make sure the seal is fully inserted and in proper position. Note picture below. Note: The flap of the cover seal must be downward and the opening must face to center of cover. A stiff bristle brush will help to knock food particles out of the blades before washing. Handle very carefully as the blades are sharp. 14 For manual cleaning, it is recommended that you use washing solutions based on non-sudsing detergents, and chlorine-based sanitizing solutions that have a minimum chlorine concentration of 100 PPM. The following washing, rinsing, and sanitizing solutions, or their equivalents, may be used: SOLUTION PRODUCT Washing Ajax® Sanitizer Cleaner Powder* DILUTION IN WATER ¼ oz. per 2½ gallons TEMPERATURE Hot 115°F (46°C) Rinsing Plain Water Warm 95°F (35°C) Sanitizing Clorox® Institutional** 1 tablespoon per gallon Cold 50°F (10°C) To clean and sanitize the motor base Clean and sanitize the motor base prior to initial use and after each use. Unplug the unit, then wipe down the exterior surfaces of the motor base with cloths or sponges dampened with a soluble detergent. Next, wipe down with rinse water. Prevent liquid from running into the motor base by wringing out all excess moisture from cloths or sponges before using them. NEVER IMMERSE THE MOTOR BASE IN WATER OR ANY OTHER LIQUID. Allow the unit to air-dry before using again. Never use harsh abrasive-type cleaners on any part of the Waring Commercial Batch Processor. Any other servicing should be performed by an authorized service representative *Ajax® is a registered trademark owned by the Colgate-Palmolive Company **Clorox® is a registered trademark owned by the Clorox Company 15