Weber 3100 LP Owner Manual - Page 19

Step 19 Install tool holders, control panel and burner control knobs You will need: three tool holders, control panel, two Phillips screws/washers, a Phillips screwdriver, and three burner control knobs. Hook the tool holders over the frame rail. Figure 26. Set the control panel in place over both frame braces. (Hold the Crossover Ignition button up while setting the control panel in place.) Line up the holes in the control panel with the holes in the inserts in the frame brace. Insert screws and tighten with a Phillips screwdriver until snug. Do not overtighten. Figure 25 (a). Push on the burner control knobs. Figure 25 (b). Insert in frame brace Step 20 Secure side burner Stand to the right side of the barbecue. Slightly pull back both side burner locks. Slide the side burner toward the control panel. The locks will snap into the slots in the front and back of the side burner. Figure 26. ƽCAUTION: Make sure both locks have snapped into place. (a) Crossover Ignition Button Tool holders Figure 25 Control panel Phillips screws/ washers (b) View from top Side view Figure 26 19