Weber 900 NG Owner Manual - Page 13
Step 8, Step 9, Step 10, General Specifications for Piping
View all Weber 900 NG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Step 8 Install manifold bracket You will need: manifold bracket Hook the bracket onto the manifold at the center burner valve. Figure 9. Place your hand underneath the bracket. Lift the manifold, bracket and cooking box slightly and hook the tab of the bracket onto the frame brace. Frame brace Manifold bracket Figure 9 Step 9 Install frame connector You will need: frame connector, two 1/4-20 x 1 3/4 inch bolts, two nylon washers and a 7/16 inch wrench. Slip a washer on a bolt and insert through the hole in the cross brace and into the end of the frame connector. Insert the other bolt and washer into the other end through the cross brace and into the frame connector. Hold the frame connector square and tighten the bolts. Figure 10. Step 10 Install gas supply General Specifications for Piping Note - Contact your local municipality for building codes regulating outdoor gas barbecue installations. In absence of Local Codes, you must conform to the latest edition of ANSI Z223.1. WE RECOMMEND THAT THIS INSTALLATION BE DONE BY A PROFESSIONAL. Some of the following are general requirements taken from ANSI Z223.1, for gas supply installations. Refer to ANSI Z223.1 latest edition for complete specifications. s This barbecue is designed to operate at 7 inches of water column pressure (.2526 psi). s A manual shut-off valve must be installed outdoors, immediately ahead of the quick disconnect. s An additional manual shut-off valve indoors should be installed in the branch fuel line in an accessible location near the supply line. s The quick disconnect connects to a 3/8 inch NPT thread from the gas source. The quick disconnect fitting is a hand-operated device that automatically shuts OFF the flow of gas from the source when the barbecue is disconnected. s The quick disconnect fitting can be installed horizontally, or pointing downward. Installing the fitting with the open end pointing upward can result in collecting water and debris. s The dust covers (supplied plastic plugs) help keep the open ends of the quick disconnect fitting clean while disconnected. ƽWARNING: Do not route the 12' hose under a deck. The hose must be visible. Figure 10 13