Weber 900 NG Owner Manual - Page 19

Step 22 Install swing table You will need: swing table assembly, support rod, support rod holder and swing table end bracket. Allow the slide bar to hang down. Push the support rod into the lower support bracket. Figure 24 (a). Swing the rod up so you can slide the rod all the way inside the locking tab. Figure 24 (b). The rod should swing freely inside the locking tab. Figure 24 (c). (b) (c) Support rod (a) Insert one end of the hinge rod into the hole in the frame. Figure 25 (a). Insert the other end into the hole in the swing table end bracket. Figure 25 (b). Hold the end bracket at an angle so the lower tab is inside the frame tube. Push the bracket into the frame. Check to see that the lower tab of the bracket is hooked in the slot in the frame. Figure 25 (c). To fully seat the bracket, you may have to tap it lightly with a hammer. ƽWARNING: If swing table end bracket is in any way cracked or damaged, do not use swing table. Call our Customer Service Center to order a new part. Install support rod holder on leg. Figure 25 (d). Hook the support rod into the support rod holder. ƽWARNING: The load limit for the swing table is 30 pounds. Hinge rod (a) (b) Figure 24 View from rear of barbecue Slot in frame (view from below) (c) (d) Figure 25 19