Weber Genesis 2000 LP Owner Manual - Page 17

Step 16 Install the lid You will need: lid, two hinge pins and two hair pin cotters. Set the lid in place from the rear of the barbecue. Close and align the hinge at the rear. Insert hinge pins from the outside through the hinge. Insert hair pin cotters into the small holes in the hinge pins. Figure 21. Hair pin cotter Hinge pin Step 17 Install tool holders, control panel and burner control knobs You will need: three tool holders, control panel and three burner control knobs. Hook the tool holders over the frame rail. Figure 22. Set the control panel in place over both frame braces. (Hold the Crossover Ignition button up while setting the control panel in place.) Place your thumbs over the control panel push-in buttons and push them into the frame brace until they snap into place. Figure 22 (a). Push on the burner control knobs. Figure 22 (b). Hole in frame brace (a) Figure 21 Tool holders Figure 22 Control panel push-in buttons (b) 17