Weber Genesis S-310 LP Owner Manual - Page 11
turn OFF the gas. DO NOT OPERATE THE GRILL. Contact - grills
View all Weber Genesis S-310 LP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
GAS INSTRUCTIONS GAS INSTRUCTIONS REMOVE CONTROL KNOBS & CONTROL PANEL FOR LEAK TESTING 1 You will need: Phillips screwdriver. 1) Remove control knobs. 2) Remove screw and washer from back of control panel with a Phillips screwdriver. 3) Tilt the back edge of the control panel up. Push in on the front edge to release locking tabs. Carefully pull control panel away from frame. 4) Disconnect the igniter wires from the ignition module. 5) Replace control panel when Leak Check is completed. 3 CHECK FOR GAS LEAKS ƽ DANGER Do not use an open flame to check for gas leaks. Be sure there are no sparks or open flames in the area while you check for leaks. Sparks or open flames will result in a fire or explosion, which can cause serious bodily injury or death and damage to property. ƽ WARNING: You should check for gas leaks every time you disconnect and reconnect a gas fitting. Note: All factory-made connections have been thoroughly checked for gas leaks. The burners have been flame-tested. As a safety precaution however, you should recheck all fittings for leaks before using your Weber® Gas Barbecue. Shipping and handling may loosen or damage a gas fitting. ƽ WARNING: Perform these leak checks even if your barbecue was dealer or store assembled. You will need: a soap and water solution, and a rag or brush to apply it. Note: Since some leak test solutions, including soap and water, may be slightly corrosive, all connections should be rinsed with water after checking for leaks. If your grill has a side burner make sure the side burner is off. To perform leak checks: open cylinder valve by turning the cylinder valve hand-wheel counterclockwise. ƽ WARNING: Do not ignite burners when leak checking. Check for leaks by wetting the connections with the soap and water solution and watching for bubbles. If bubbles form or if a bubble grows, there is a leak. 11 2 11 4 310 Check: 1) Hose-to-manifold connection. ƽ WARNING: If there is a leak at connection (1), retighten the fitting with a wrench and recheck for leaks with soap and water solution. If a leak persists after retightening the fitting, turn OFF the gas. DO NOT OPERATE THE GRILL. Contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®. 2) Regulator-to-cylinder connection. 3) The hose-to-regulator connection. 4) Valves-to-manifold connections. ƽ WARNING: If there is a leak at connections (2), (3) or (4), turn OFF the gas. DO NOT OPERATE THE GRILL. Contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®. When leak checks are complete, turn gas supply OFF at the source and rinse connections with water. *The grill illustrated may have slight differences than the model purchased. WWW.WEBER.COM®