Weber Genesis S-310 LP Owner Manual - Page 17

PROBLEM Side Burner does not light. Flame is low in "HI" position. Push button ignition does not work. SIDE BURNER TROUBLESHOOTING CHECK Is gas supply off? Turn supply on. CURE 17 17 The excess flow safety device, which is part of the barbecue to cylinder connection, may have activated. Is the fuel hose bent or kinked? Does burner light with a match? To reset the excess flow safety device turn all burner control knobs and the cylinder valve off. Disconnect the regulator from the cylinder. Turn burner control knobs to START/HI. Wait at least 1 minute. Turn burner control knobs to "OFF". Reconnect the regulator to the cylinder. Turn cylinder valve on slowly. Refer to "Lighting Instructions". Straighten hose. If match lights burner, check igniter (see Sideburner Maintenance). If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®. SIDE BURNER MAINTENANCE SIDE BURNER MAINTENANCE ƽ WARNING: All gas controls and supply valves should be in the "OFF" position. Make sure black wire is connected between the igniter and electrode. Make sure white wire is connected between the igniter and grounding clip. Spark should be a white/blue color, not yellow. 1) Igniter Wire 2) Ground wire 3) Burner Side Burner Grate Side Burner cap Side Burner Ring & Head Igniter Electrode Control Knob Igniter MAINTENANCE WEBER® SPIDER/INSECT SCREENS Your Weber® gas barbecue, as well as any outdoor gas appliance, is a target for spiders and other insects. They can nest in the venturi section (1) of the burner tubes. This blocks the normal gas flow, and can cause the gas to flow back out of the combustion air opening. This could result in a fire in and around the combustion air openings, under the control panel, causing serious damage to your barbecue. The burner tube combustion air opening is fitted with a stainless steel screen (2) to prevent spiders and other insects access to the burner tubes through the combustion air openings. We recommend that you inspect the Spider/Insect screens at least once a year. (See Section "Annual Maintenance".) Also inspect and clean the the Spider/Insect screens if any of the following symptoms should ever occur: 1) The smell of gas in conjunction with the burner flames appearing yellow and lazy. 2) Barbecue does not reach temperature. 3) Barbecue heats unevenly. 4) One or more of the burners do not ignite. ƽ DANGER Failure to correct the above mentioned symptoms may result in a fire, which can cause serious bodily injury or death, and cause damage to property. WWW.WEBER.COM®