Weed Eater WE EL-15TNE Owner Manual - Page 5

Edge Guide Shield 2. Insert the shield onto the motor housing. Ensure the cutting head remains free to rotate and the line is not caught between the shield and the motor housing (see following illustration). 3. Twist the shield as illustrated until the hole in the shield aligns with the hole in the housings. Make sure the shield is assembled to the unit as shown in the following illustration and in the KNOW YOUR UNIT section of this manual. 4. Install bolt into shield and motor housing as shown. Tighten securely. CAUTION: Sharp line limiter blade Holes Bolt Twist shield in this direction to assemble OPERATION KNOW YOUR TRIMMER READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT. Compare the illustrations with your unit to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference. Trigger Switch Assist Handle Twist and Edge Button Motor Housing Cord Retainer Clamp Recessed Plug Locking Sleeve Assembly Air Vents Debris Shield Edge Guide Trimmer Head with 0.065 inch Trimmer Line RECESSED PLUG The RECESSED PLUG is where you attach your extension cord to the unit. TRIGGER SWITCH The TRIGGER SWITCH is used to turn on the unit. Squeeze the trigger switch to operate the unit. Release to stop. LINE LIMITER BLADE The LINE LIMITER BLADE cuts the cutting line to the proper cutting length. ASSIST HANDLE The ASSIST HANDLE is used to help hold and guide the unit. Line Limiter Blade TRIMMER HEAD The TRIMMER HEAD holds the cutting line and rotates during operation. TWIST AND EDGE BUTTON The TWIST AND EDGE BUTTON is used to twist the lower portion of the unit into an edging position. EDGE GUIDE The EDGE GUIDE protects the unit from contacting the ground during edging. 5