Weed Eater WE EL-15TNE Owner Manual - Page 9

USER REPLACEABLE SERVICE PARTS REPLACEMENT PART Spool with 0.065 inch Trimmer Line Assist Handle Bolt Carriage, M6 X 1 Knob Clamp Shield Assembly Edge Guide Spool cap Bolt PART NUMBER 952711920 574495601 574495901 574473101 574495801 574495401 574491601 574492201 574471601 STORAGE WARNING: Perform the following steps after each use. • Stop the unit and disconnect the power source when not in use. • Carry the unit with motor stopped. • Store the unit so the line limiter blade can- not cause injury. • Store unit and extension cord indoors in a high, dry place out of the reach of children. Store unit unplugged. • Store unit with all guards in place. Position unit so that any sharp object cannot accidentally cause injury. TROUBLESHOOTING TABLE WARNING: Always stop unit and disconnect from the power source before per- forming all of the recommended remedies below except remedies that require unit to be operating. TROUBLE Trimmer head stops under a load or does not turn when switch is pressed. CAUSE 1. Crowding trimmer line against material being cut. 2. Electrical failure. 3. Thrown circuit breaker. 4. Debris stopping head. REMEDY 1. Allow tip of line to do the cutting. 2. Contact your authorized service dealer. 3. Check breaker box. 4. Remove debris. Line does not advance or breaks while cutting. 1. Line improperly routed in head. 2. Line improperly wound into spool. 3. Incorrect line size 4. Not enough line outside of head. 5. Dirt buildup on unit. 1. Check line routing. 2. Rewind line tightly and evenly. 3. Use only 0.065 inch (1.65 mm) dia. line. 4. Remove spool cap and pull 4 inches (10 cm) of line out of head. 5. Clean unit. Line welds onto spool. Line releases continuously. 1. Line size is incorrect. 2. Incorrect spool. 3. Line is being crowded against material being cut. 1. Line improperly routed in head. 2. Spool damaged. 1. Use only 0.065 inch (1.65 mm) dia. line. 2. Replace with correct spool. 3. Cut with tip of line fully extended. 1. Check line routing. 2. Replace spool. Line usage is excessive. 1. Line improperly routed in head. 2. Line size is incorrect. 3. Crowding line against material being cut. 4. Spool worn or damaged. 1. Check line routing. 2. Replace spool. 3. Cut with tip of line fully extended. 4. Replace spool. Line pulls back into head. 1. Too little line outside of head. 2. Line size incorrect. 1. Remove spool cap and pull 4 inches (10 cm) of line outside of head. 2. Use only 0.065 inch (1.65 mm) dia. line. 9