Weider 130 Bench English Manual - Page 7

2. Attach the Front Leg (2) to the Frame (1) with two M10 x 65mm Bolts (17), two M10 Large Washers (20), and two M10 Nylon Locknuts (19). Do not tighten the Nylon Locknuts yet. 2 20 17 20 19 19 1 2 3. Press two 50mm Round Outer Caps (12) onto 3 the other Stabilizer (4). Orient the Stabilizer (4) so that the indents and the decals are in the positions shown, and attach the Stabilizer to the Rear Leg (3) with two M10 x 63mm Carriage Bolts (18) and two M10 Nylon Locknuts (19). Do not tighten the Nylon Locknuts yet. Attach the Rear Leg (3) to the Frame (1) with two M10 x 25mm Bolts (25) and two M10 Large Washers (20). Tighten the M10 Nylon Locknuts (19) used in steps 1-3. 4. Orient the Pivot Bracket (6) as shown, and 4 attach it to the Backrest Frame (5) with two M8 x 68mm Bolts (26) and two M8 Nylon Locknuts (27). Orient the Backrest (7) as shown, and attach it to the Backrest Frame (5) with four M6 x 16mm Bolts (24). Warning 12 Decal Indents 19 18 13 20 20 19 4 25 12 7 Wide End 24 27 6 5 24 24 26 7