Weider 215 English Manual - Page 7

3. Press a 2 1/2Ó Square Bushing (23) onto both the Right Upright (5) and the Left Upright (4). Slide the Weight Rests (6) into the Uprights and secure them at the desired height with two Adjustment Knobs (27). Both Weight Rests should be set at the same height. 4. Press two 38mm Square Inner Caps (32) into the ends of the Left Fly Arm (8). Press a 1Ó Round Inner Cap (21) into the end of the weight tube of the Fly Arm. Slide a Weight Stop (34) over the weight tube. Press two 1Ó Round Inner Caps (21) into a Fly Arm Pad Tube (10). Attach the Fly Arm Pad Tube to the Left Fly Arm (8) using an M8 x 50mm Bolt (52), two M8 Flat Washers (41), an M8 Spacer (43), and an M8 Nylon Locknut (50). The Spacer should fit snugly into the Left Fly Arm. Slide a Small Foam Pad (22) onto the Fly Arm Pad Tube. Assemble the Right Fly Arm (7, not shown) in the same manner. 5. Attach the Left Fly Arm (8) to the Left Upright (4) using two Nylon Bushings (30) and a Spring Clip (29). Attach the Right Fly Arm (7) to the Right Upright (5) in the same manner. 3 6 27 5 6 23 27 4 4 8 52 41 43 10 21 22 21 41 Weight Tube 32 32 50 21 34 5 5 22 7 29 30 4 8 22 6. Press two 38mm Square Inner Caps (32) into the ends of the Leg Lever (9). Press a 1Ó Round Inner Cap (21) into the indicated end of the weight tube. Slide a Weight Stop (34) over the weight tube. Press a 1Ó Round Angle Cap (53) onto the opposite end of the weight tube. Insert 3/4Ó Round Inner Caps (47) into the ends of two Pad Tubes (48). Slide the Pad Tubes into the holes at the ends of the Leg Lever (9). Slide Large Foam Pads (33) onto the ends of the Pad Tubes. 6 33 9 32 33 34 53 47 48 33 21 Weight Tube 32 47 48 33 7