Weider 215 English Manual - Page 8

7. Press two 3/4Ó Round Inner Caps (47) into the ends of a Pad Tube (48). Slide the Pad Tube through the large hole in the Front Leg (2) as shown. Slide a Large Foam Pad (33) onto each end of the Pad Tube. Attach the Leg Lever (9) to the Front Leg (2) using an M10 x 64mm Bolt (46) and an M10 Nylon Locknut (45). 7 33 47 48 45 9 2 46 33 8. Press 1Ó Square Inner Caps (39) into the ends of both Backrest Tubes (20). Lubricate an M10 x 8 21 168mm Bolt (40). Attach the Backrest Tubes to the Bench Frame (1) with the lubricated Bolt, two M10 Pin Flat Washers (54), and an M10 Nylon Locknut (45). Do not overtighten the Locknut. You must be 5 able to freely pivot the Backrest Tubes (20). 20 37 21 39 Press two 1Ó Round Inner Caps (21) into the Adjustment Tube (37). With the pins on the 39 45 Adjustment Tube facing downward, slide the Adjustment Tube into the adjustment brackets on the Uprights (4,5). 54 54 Bracket 4 40 Tighten the Nylon Locknuts used in step 2. 1 9. Attach the Seat (16) to the Bench Frame (1) using two M6 x 16mm Screws (56), one M6 x 62mm 9 Screw (38), and one M6 Flat Washer (51). 16 1 51 56 38 8