Weider 8520 User Manual - Page 12
Pulley 15. Attach the Pulley to the Rocker - cable routing
View all Weider 8520 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
CABLE ASSEMBLY 22. Locate the Short Cable (58). Route the 22 Short Cable under the 3 1/2" Low Pulley (77). Be sure that the end of the Cable with the ball is on the indicated side of the Pulley and that the Cable is between the Pulley and the welded spacer on the Leg Lever (29). Tighten the 3/8" x 3 1/2" Bolt (16) and the 3/8" Nylon Locknut (not shown). 23. Wrap the Short Cable (58) around a "V"- Pulley (6). Attach the Pulley and a Long 23 Cable Trap (50) inside the bracket on the Seat Frame (36) with a 3/8" x 2 1/2" Bolt (7) and a 3/8" Nylon Locknut (21). Be sure that the Cable Trap is turned to hold the Cable in place and that the Cable is routed around the Pulley as shown. 29 16 58 77 Ball Welded Spacer 6 58 21 24. Wrap the Short Cable (58) around a 3 1/2" Pulley (15). Attach the Pulley to the Rocker Arm (32) with a 3/8" x 3 1/2" Bolt (16), a 3/8" Flat Washer (9), and a 3/8" Nylon Locknut (21). Be sure that the Cable Trap (66) is turned to hold the Cable in place and that the Cable is routed around the Pulley as shown. 50 7 36 24 32 15 66 16 58 21 9 25. Note: The 3 1/2" Pulley (15) labeled in this step is pre-attached. It is shown removed for easy part identification. Route the Short Cable (58) around the 3 1/2" Pulley (15) attached to the lower hole in the Front Upright (42). Be sure that the Cable Trap (66) is turned to hold the Cable in place and that the Cable is routed around the Pulley as shown. Tighten the 3/8" Nylon Locknut (21) and the 3/8" x 3 3/4" Bolt (71). 25 42 71 15 66 21 58 9 12