Weider 8775hard Drive Sys English Manual - Page 21
Trouble, Shooting, Maintenance
View all Weider 8775hard Drive Sys manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
TROUBLE-SHOOTING AND MAINTENANCE Inspect and tighten all parts each time you use the hard drive system. Replace any worn parts immediately. The hard drive system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents. TIGHTENING THE CABLES Woven cable, the type of cable used on the hard drive system, can stretch slightly when it is first used. If there is slack in the cables before resistance is felt, the cables should be tightened. Follow the instructions below to tighten the cables. Remove the 5/16" x 1 1/4" Bolt (2), Weight Bracket (110) and 1/2" x 7/16" Bushing (134) from the Weight Tube (108) in the rear weight stack. Remove the 70 Cable Bracket (135) from the Weight Tube. Tighten the 1/4" Nylock Nut (5) farther onto the end of the 135 5 Weight Cable (70). Reassemble the parts. Repeat, if 108 necessary, until there is no slack in the cables. Make sure that the cable is not too tight, or the top weight will be lifted off the weight stack. 134 0 110 If the cables cannot be tightened enough as described above, the cables may need to be replaced. See the 2 back cover of this owner's manual for information about ordering replacement parts. Locate the adjustment sleeve and adjustment screw near the lower end of the Pulley Cable (69). Loosen the adjustment screw. Pull the end of the Pulley Cable until the Pulley Cable is tight, slide the adjustment sleeve and the ball against the low pulley, and retighten the adjustment screw. Make sure that the cable is not too tight, or the top weight on the rear weight stack will be lifted off the weight stack. Low Pulley Station 0 If the cables cannot be tightened by following the instructions above, see the instructions below. Adjustment Screws"-----T 69 Adjustment Sleeve 21