Weider Be Pro 265 Bench Enc Manual - Page 6
Part Identification Chart
 |
View all Weider Be Pro 265 Bench manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
PART IDENTIFICATION CHART Use the drawings below to identify the small parts needed for assembly. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. Note: If a part is not in the hardware kit, check to see if it has been preassembled. Extra hardware may be included. M8 Locknut (17) M10 Locknut (33) M6 Washer (26) M8 Washer (16) M4 x 19mm Screw (19) M6 x 40mm Screw (30) M8 x 15mm Screw (37) M8 x 75mm Bolt (32) M10 x 60mm Carriage Bolt (34) M10 x 77mm Carriage Bolt (18) 6
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8 -
9 -
10 -
11 -
12 -
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
 |
 |
6
Use the drawings below to identify the small parts needed for assembly. The number in parentheses below each
drawing is the key number of the part, from the PART LIST near the end of this manual.
Note: If a part is not in
the hardware kit, check to see if it has been preassembled. Extra hardware may be included.
M8 Locknut (17)
M10 Locknut (33)
M8 Washer (16)
M6 Washer (26)
M10 x 77mm Carriage Bolt (18)
M10 x 60mm Carriage Bolt (34)
M8 x 15mm
Screw (37)
M8 x 75mm Bolt (32)
M6 x 40mm Screw (30)
M4 x 19mm
Screw (19)
PART IDENTIFICATION CHART