Weider Bench 250 English Manual - Page 9

9. Orient the Backrest Tubes (7) with the indicated 9 holes in the position shown. Attach the Backrest Tubes to the Backrest (8) with four M6 x 38mm Screws (32) and four M6 Washers (22). Do not 8 tighten the Screws yet. 7 Holes 22 7 22 32 10. Lubricate an M10 x 142mm Bolt (23) with the included grease packet. Attach the Backrest Tubes (7) to the welded tube on the Bench Frame (3) with the Bolt, two M10 Washers (30), and an M10 Nylon Locknut (31). Do not overtighten the Nylon Locknut; the Backrest Tubes must pivot easily. See step 9 and tighten the M6 x 38mm Screws (32). 32 10 30 31 7 3 Tube 11. Attach the Seat (9) to the Bench Frame (3) with 11 four M6 x 16mm Screws (24). Make sure that 9 the Seat is oriented as shown. 30 23 Lubricate 12. Make sure that all parts are properly tightened before you use the weight bench. The use of all remaining parts will be explained in ADJUSTMENT, beginning on page 10. 3 24 24 9