Weider Club 290 Power Tower Bench English Manual - Page 6
Assembly - computer tower bench
View all Weider Club 290 Power Tower Bench manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
ASSEMBLY To make assembly easier, carefully read the following information and instructions: • For help identifying small parts, use the PART IDENTIFICATION CHART on page 5. • To hire an authorized service technician to assemble the weight bench in your home, call 1-800-445-2480. • Assembly requires two persons. • Because of its weight and size, the exercise tower should be assembled in the location where it will be used. Make sure that there is enough clearance to walk around the exercise tower as you assemble it. • Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. • The following tools (not included) may be required for assembly: two adjustable wrenches one rubber mallet one standard screwdriver one Phillips screwdriver Assembly may be more convenient if you have a socket set, a set of open-end or closed-end wrenches, or a set of ratchet wrenches. 1. Before beginning assembly, make sure you understand the information in the box above. Orient the two Base Frames (1), the Center Base (4), and the Rear Base (35) as shown. Make sure that the large warning decal on the Center Base is in the position shown. Attach the Center Base (4) to the two Base Frames (1) with four M10 x 90mm Bolts (19), four M10 Washers (30), and four M10 Locknuts (25). Do not tighten the Locknuts yet. Attach the Rear Base (35) to the two Base Frames (1) in the same way. 1 25 30 1 Large 30 35 Warning Decal 4 19 19 30 30 25 1 6