Weider Club 290 Power Tower Bench English Manual - Page 8

4. Attach the Left Handle (9) to the Left Pull-up Arm (34) with an M10 x 65mm Screw (29), an 4 M10 x 70mm Screw (31), and two M10 Washers (30). 7 Press a 50mm Round Inner Cap (12) into the Left Pull-up Arm (34). Make sure that the thick side of the Cap is on the side shown. Attach the Right Handle (8) to the Right Pullup Arm (7) in the same way. 8 Thick Side 9 Thick Side 30 12 29 34 30 31 5. Insert the Left Pull-up Arm (34) into the Upright (3). 5 Attach the Left Pull-up Arm (34) to the Upright (3) with an M10 x 75mm Screw (36) and an M10 Washer (30). Do not tighten the Screw yet. Attach the Left Pull-up Arm (34) with an M10 x 70mm Screw (31), an M10 Washer (30), and an M10 Locknut (25). Then, tighten the M10 x 75mm Screw (36). Attach the Right Pull-up Arm (7) to the Upright (3) in the same way. 7 3 31 36 30 25 34 8