Weider Club 540 English Manual - Page 9
Attach the Short Cable 33 to the Weight Base
View all Weider Club 540 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
15. Route the Long Cable (34) up through the Weight Frame (10), over a 3 1/2" Pulley (27), and back 15 down through the Weight Frame. Attach the Pulley to the Weight Frame with an M10 x 75mm Bolt (31), two Short Spacers (32), two M10 Washers (24), and an M10 Nylon Locknut (26). 16. Attach the metal-sleeve end of the Long Cable (34) to the M10 x 19mm Bolt (40) on the Weight 16 Carriage (13) with an M10 Nylon Locknut (26). Do not overtighten the Nylon Locknut; the Cable must be able to pivot freely. 17. Locate the Short Cable (33); note that there are 17 two balls on one end of the Short Cable and a metal sleeve on the other end. Lay the ball-end of the Short Cable (33) inside the bracket on the Center Base (7). Attach a 3 1/2" Pulley (27) inside the bracket using an M10 x 45mm Bolt (29) and an M10 Nylon Locknut (26). 18. Wrap the Short Cable (33) around a 3 1/2" Pulley (27) as shown. Attach the Pulley and a Cable 18 Trap (39) to the Pulley Plates (28) with an M10 x 45mm Bolt (29) and an M10 Nylon Locknut (26). 19. Attach the Short Cable (33) to the Weight Base 19 (20) with an M10 x 75mm Bolt (31), two M10 Washers (24), two Long Spacers (41), and an M10 Nylon Locknut (26). 31 24 27 32 32 24 34 26 10 13 40 26 34 27 29 33 26 7 29 28 26 27 33 39 31 33 24 20 41 41 24 26 9