Weider Pro 220 Bench English Manual - Page 8
Pad Tube 12. Slide the Pad Tube into the Leg
View all Weider Pro 220 Bench manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
5. Attach the Bench Frame (3) to the Crossbar (2) with two M10 x 68mm Bolts (27) and two M10 5 Nylon Locknuts (31). Tighten the M10 Nylon Locknuts (31) used in steps 1-5. 3 2 27 31 6. Press a 25mm Round Inner Cap (20) into the indicated end of the weight tube on the Leg Lever (6). Press a 25mm Round Angled Cap (17) onto the other end of the weight tube. Tap two 38mm Square Inner Caps (18) into the Leg Lever (6). Lubricate the M10 x 60mm Bolt (25) with grease. Attach the Leg Lever (6) to the Front Leg (4) with the Bolt and an M10 Nylon Locknut (31). Do not overtighten the Locknut; the Leg Lever must be able to pivot easily. 7. Press two 25mm Square Inner Caps (19) into a Pad Tube (12). Slide the Pad Tube into the Leg Lever (6). Slide two Foam Pads (13) onto the ends of the Pad Tube. Make sure the Foam Pads are oriented as shown. Repeat this step with the other Pad Tube (12). 6 18 31 4 6 17 20 18 7 6 13 19 25 Lubricate 12 19 13 8. Press a 25mm Round Inner Cap (20) into a Weight Rest (15). Insert the Weight Rest into an Upright (1). Turn the Weight Rest so the locking pin is wrapped around the Upright. Repeat this step with the other Weight Rest (15). 8 15 12 Locking Pin 20 1 15 8