Weider Pro 365 Bench English Manual - Page 7
do not fully tighten the, Screws yet., Do not overtighten, the Locknut; the Backrest Frame must
View all Weider Pro 365 Bench manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
3. Orient the Backrest Frame (3) so that the welded tubes (A) are in the position shown. In addition, 3 orient the Backrest Bracket (5) as shown. Attach the Backrest Bracket (5) to the Backrest Frame (3) with four M8 x 15mm Screws (13) and four M8 Washers (18); do not fully tighten the Screws yet. 3 18 13 18 18 13 18 A 5 4. Insert the end of the Backrest Bracket (5) into the Frame (1), and then attach the Backrest 4 Frame (3) to the Frame with an M12 x 100mm Bolt (14), two M12 Washers (15), and an M12 Locknut (16) as shown. Do not overtighten the Locknut; the Backrest Frame must pivot freely. See step 3. Tighten the M8 x 15mm Screws (13). See the inset drawing. Firmly tighten one of the Adjustment Knobs (9) into the Frame (1) and into one of the adjustment holes in the Backrest Bracket (5). Then, tighten one of the Stop Screws (17) into the end of the Backrest Bracket. 5 1 3 5 15 14 9 15 16 1 17 7