Weider Pro Xt75 English Manual - Page 12

ADJUSTMENTS This section explains how to adjust the weight rack. See the EXERCISE GUIDELINES on page 14 for important information about how to get the most benefit from your exercise program. Also, refer to the accompanying exercise guide to see the correct form for each exercise. Inspect and tighten all parts each time you use the weight rack. Replace any worn parts immediately. The weight rack can be cleaned with a damp cloth and a mild, non-abrasive detergent. Do not use solvents. USING THE WEIGHT RESTS AND WEIGHT SPOTTERS Before beginning an exercise, move the Weight Rests (19, 48) and the Weight Spotters (20, 49) to sets of holes in the uprights that are best suited for that exercise. The selected holes for the Weight Spotters should represent the lowest point to which you want the barbell to go during the exercise. The selected holes for the Weight Rests should be at a comfortable height for lifting and replacing the barbell. Perform the exercise as shown in the accompanying exercise guide. Note: Make sure the Adjustment Knobs (22) are fully tightened. 19 20 22 WARNING: Always set both Weight Rests (19, 48) at the same height and both Weight Spotters (20, 49) at the same height. SETTING UP THE RACK FOR SQUAT EXERCISES Squat exercises should be performed inside the rack (behind the dotted line in the picture). When performing squat exercises, set the Weight Rests (19, 48) and the Weight Spotters (20, 49) at a comfortable height. WARNING: Always move the bench (not included) when you are performing squat exercises inside the rack. 19 20 48 49 Squat Area 12