Weslo 65 Treadmill English Manual - Page 8

5. While a second person holds the console assembly near the Handrail (20), attach the 5 ground wire to the indicated hole in the Handrail with a Ground Screw (33). Ground Wire 33 Hole 20 Console Assembly 6. While the second person continues to hold the console assembly, locate the wire underneath 6 the console assembly. Connect the wire from the console assembly to the Wire Harness (77). See the inset drawing. The connectors should slide together easily and snap into place. If the connectors do not Wire 77 slide together easily and snap into place, turn one connector and then try again. IF THE CON- NECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Insert Console 77 Assembly the connectors downward into the Handrail (20). 20 7. Set the console assembly on the Handrail (20). Be careful to avoid pinching any of the wires. Make sure that the ground wire (see step 5) and the wire from the console assembly (see step 6) are in the indicated channel. Hand tighten five Screws (3) into the Handrail (20) and the console assembly. Do not put Screws into the two indicated holes. Start all five Screws, but do not tighten them yet. 7 Channel Console Assembly 20 3 3 3 No Screws 8