Weslo Ascent 775 English Manual - Page 8

TROUBLE-SHOOTING AND MAINTENANCE Inspect and tighten all parts of the stepper regularly. Be sure that the cotter pins are securely attached to the clevis pins in the pedals. Outside surfaces of the stepper can be cleaned using a soft cloth and mild, nonabrasive detergent. Keep all liquids away from the programmable console. LUBRICATING THE LINK ARMS The axles to which the Link Arms (54) are attached should be oiled ever six months, or whenever the joints become noisy. Apply a few drops of light, multi-purpose oil at the locations indicated in the drawing. Apply Oil Apply Oil LUBRICATING THE CLEVIS PINS The Clevis Pins (51) in the pedals should be greased every six months, or whenever the pedals become noisy. Remove the Cotter Pins (52) from the Clevis Pins, and slide the Clevis Pins out of the pedals. Apply grease to the Clevis Pins. Reattach the pedals. Apply Grease 51 ADJUSTING THE REED SWITCH IMPORTANT: For the exercise monitor to operate properly, you must move the pedals vertically at least 8 inches as you exercise. If your steps are too shallow, they will not be detected by the exercise monitor. 50 If the monitor still does not operate properly, the Reed Switch (56) should be adjusted. Hold down the left pedal so the Magnet (50) is level with the Reed Switch. 56 Slide the Reed Switch in or out of the holder until there is a 3/16" gap between the Reed Switch and the 8 Magnet.